2003 BMW M3 HPF HorsepowerFreaks SILVER/BLACK HPF STAGE 3 998HP - 601 FT-LBS TQ

This three owner 2003 M3 was last purchased in 2006 with 19k miles. The previous owner then shipped the car to HorsePowerFreaks (HPF) in Oregon in February 2010 with approximately 75k miles and has spent over $50,000 to have one of the fastest and most reliable M3 builds available! If you aren't familiar with HorsePowerFreaks they were THE premier engine builder for E46 M3's and unfortunately closed shop years later due to an employee who was stealing money from the company. HPF is the only company who has delivered well built and tested high horsepower builds with a standing following as no other company to date has delievered the same performance and build quality. The previous owner originally spent $39,000 on the Stage 3 build in February 2010. After driving a couple thousand miles, he felt the car wasn't putting all the power to the ground and wanted a new block so he shipped the car back to HPF and they installed a brand new block and built a brand new engine in June of 2011 which cost $15,200 to have this completed. The new engine has less than 10,000 miles since the build. This M3 produces 998 horsepower at the crank and with a 4 inch Titanium HPF Stage 3 exhaust, this car sounds mean! With as much power as this vehicle produces, this car is still capable of being driven as a daily driver and is very comfortable doing so.

In 2010, HorsepowerFreaks installed an E46 M3 Stage 3 left hand drive turbo kit. The vehicle wasDyno Tested at 789.89RWHP and 601.59 FT-LBS of Torque. The graphical results are shown in the photos.

1. Active Autowerke M3 Short Shifters - E46 - Level 2 w/ Shift Boot - $280.00

2. HorsepowerFreaks M3 E46 M3 Feramic Stage 3 Clutch Kits - $1,050.00

3. HorsepowerFreaks M3 E46 M3 Methanol Activation Switches - $140.00

4. HorsepowerFreaks M3 E46 M3 Turbo Kits - Stage 3 - Left Hand Drive - No SMG - $31,995.00

5. HorsepowerFreaks M3 Front Lower Under Braces - Powdercoated Black - $349.00

6. K Sport M3 - 14 inch rotors - 8 piston- $1,850

7. K Sport M3 -13 inch rotors - 6 piston - $1,550

8. Specialty Products M3 Rear Camber Kits - E46 Billet Aluminum: -1 to +4 Degrees (1 per axle) - $275.00

9. Installation of Turbo System and machine work on the engine - $6,500

10. Subframe reinforcement - $1,850

11. New Engine build - $15,200 cost.

The M3 has seen an interior, exterior, and engine bay detail. The vehicle comes with a clean Autocheck Vehicle History Report and 2 keys. Vehicle also comes with a binder from HPF documenting all work completed including all stages, traction control, fuel system, water lines and the subframe reinforcement which was completed. Within the binder you will also find all information on a cd and receipts and copies of all documents and services performed.

On 07/20, we performed a compression test and the results are as follows:

Cyl 1- 120psiCyl 2- 125psiCyl 3- 123psiCyl 4- 124psiCyl 5- 120psiCyl 6- 119psi

Overall, the engine has been well maintained and the compression test shows well for a Stage 3 HPF.

Please consider this an invitation to visit Gator Motorsport! If you have any questions or wish for more information about this vehicle or any other vehicle, please do not hesitate to call Brian Henry @ 317-245-6312 or emailBrian@GatorMotorsport.com