Step Van, Milk, Bread, Delivery, Box Truck, Non-operable, project, rare, P10

RARE 1965 CHEVROLET STEP VAN

Super rare 1965 Chevrolet Step Van delivery vehicle manufactured in Canada. Body was madeby Commercial Body Builders Ltd of Vancouver, .C. Thechassis is a 1965 Chevy short wheelbase P10 Forward Control chassis. Some have suggested that this is a Divco Dividendmodel, ut it is not. CBB manufactured a short run of these in 1965 and 66. It is estimated that they made half a dozen only in 1965.

FEATURES: This vehicle has a unique design using a one piece fibreglass front and roof section. The sides and rear panels are sheet metal. It has curved Plexiglas front corner windows to eliminate blind spots. The exterior paint on the roofdoes not cover the centersection which makes for an interesting translucent skylight in the interior.

THE GOOD: Having a 1965 chassis means it has fairly modern style running gear with an independent front suspension and a trailing arm rear suspension. It has a 12 bolt rear axle with positraction. It has unique tri-bar style front signal lights. The fiberglas overall is in great condition. It has straight body panels on both sides. The front section inside is checkerplate with the parcel area being hardwood. It is in good shape too. Corvair style dashboard. Has sliding pocket doors on both sides. Rear doors are barn doors.

THE BAD: The front bumper is missing. It uses a 60-66 Chevy truck bumper. The grille is bent a bit, ut should be an easy fix. The glass is old and has cracks and fogging. It is all flat glass. The front Plexiglas corner windows are hazed badly. The front wheel well on the passenger side has some cracks. The passenger door has no outside door handle. Drivers seat is garbage. Sliding doors will need some lube. Step wells both have little areas of rust that will need patching. There is a hole cut into the ceiling just above the drivers seat. Most likely for a vent. Rub rails on both sides have some pin hole rust areas. Both lower body panels on sides have been replaced with galvanized material andpaint is not adhering. Rear corners both have rust at bottoms. Rear bumper is tweaked and should probably be removed. The rear doors have no glass, r handles. Rear tail lights are missing, ut they are standard 4" round lenses. Tires are garbage.

THE EXTRAS: Included in this auction are parts necessary to upgrade the suspension. There is a complete Chevy Truck front suspension, hich is a bolt in. This front end has lowering springs and dropped spindles for a total drop of about 3 1/2". It has heavy duty disc brakes with new calipers and brake lines. The brake system is completed with a mid90s Dodge full size van power brake master cylinder with a 90 degree mount. The 12 bolt rear can be upgraded with the included NEW axle shafts to convert it to 5 bolt wheel pattern matching the truck front end. Included are NEW rear brake drums to match the 5 bolt pattern. The front suspension can be rebuilt using the INCLUDED NEW upper and lower ball joints, ie rod ends, nd upper and lower A-arm bushings. There is also included a truck power steering box and NEW mounting plates to mate it to the 1965 chassis. Included also NEW lowering blocks for the rear axle. NOTE: The tires shown in the pic of the replacement front suspension are NOT included in this auction. Also, his vehicle does not have the emblems as shown on the van with the red paint. That picture is included only to demonstrate the manufacturer.

DISCLAIMER: The seller has a clean title for this vehicle in British Columbia, ANADA. The seller will furnish both a bill of sale and a Title transfer to the winning bidder. The vehicle is being sold without warranty, s is, nd where is. Any extra cost related to this purchase in regards to duty, axes, hipping, r other are the express responsibility of the seller. The seller recommends that bidders try and personally check out the vehicle before bidding. The vehicle is located in Vernon, .C., ANADA

AS PER REQUESTS: Length 12 foot, idth 77 inches, eight 92 inches overall.

Any questions about this item need to be asked before the auction ends.

The seller reserves the right to refuse any bids if he feels unsure about the bidder

Seller is not responsible for continual storage of this vehicle unless arrangements

have been made prior to the end of the auction.