chevrolet s-10 project bagged V8 wilwoods

This is a bagged s-10 PROJECT . It has no motor or trans. It's basically a rolling chassis. I was gonna put a 1949 Chevy truck on this frame but my plans changed . I started painting it but there are some flaws in paint and I sanded some of it down to touch u, then never did it . Here are some of the parts/mods :Thorbeck brothers 3 link converted to 5 link bag on barRe8s in bac, re7s in front3/8 for plastic and stainless airlinesMmw upper control armsDjm drop lower control arms plated for bagsDc5000 compressor Sms check valvesSmc water traps Smc valvesWillwood brakes all the way aroundMini spool locking rear endBoyd Coddington 18s powdered coated blackFrame cleaned and epoxy primered and paintedEvery bushing bearing and seal is 100% new on truck with zero milesCross member notched and plated to fit v8Trans mount modded to tuck exhaust between tranny and frame rails3rd brake shave, door handles shavedFuel cel, aluminum lines ran . New brake lines ra, some braided brake lines, small 7 inch brake booste, I have interior except seat, but none is in the truck due to painting . It had tan interior I swapped out for black dash and panels etc.I have electrical harnesses for 4.3I have multiple door, gril, headlight, new carpe, all glas, door part, A lot of extra parts . Don't have be, seats or hood. Again this is a project !!!!!!!!!!!!Any questions please email me or call/txt . 814-three three one-6347
This truck is a perfect chassis to set a classic truck on ! I have the notorized title I never tranfered into my name because I was going to title it a 1949.LOW RESERV, no shippin, you come get i, I'll help load it . The address its stored at is 819 n. Main Street port allegany pa 16743