1976 Chevrolet K10, New Engine/Trans

Its finally time to sell this project I have been working on. It is somewhat of a project. and is no longer worth my time. I am too busy with school. so the truck has to go. The Bad:Has sat for a year. only started once in a while. Needs BatteryCould use some carb tuningThe body needs work. The floorboards are rusted. and the rocker panels are completely rusted out. The rockers will most definitely need to be replaced at some point. The paint was done by the previous owner. an amateur job. The bench seat has a rip in the drivers side. There are random spots of surface rust. There was a bit of bad bondo work done beneath the drivers side mirror. That pretty much sums up the bad things about the truck. If you know your body work then this truck is definitely for you. If not. most of the work can be left as is or done for not a very expensive price. The Good:Tires: 35in BFG with about 75% life leftTransmission: TH350 rebuilt by Strange transmission with about 50 miles on itEngine: 350SBC mild build by Bowtie Performance with 0 miles on it. I started it once that's it. needs to be broken in. Axles: It has a Dana44 up front and a 10 bolt in the rear. previous owner claimed 4. 10 gearingOther parts: Edelbrock 650 carb and RPM series intake mani. new distributor. new flex plate. new fuel pump. new gas lines. new valve covers. new brake booster. new battery. new transmission cooler. Literally everything under the hood is new. The dash was swapped for a crack free original one. The seat is in pretty good condition. Lets talk lift: It is sitting on 2 inch body lift. Previous owner did it. I have all of the components to make the best lift you can put on a K10 no doubt about it. I have DIY4x shack flip kit for the rear. a spring hanger kit for the front to run 56" leafs. shackles for all points. and Bilstein 5150 shocks all around. NONE of this is installed. I don't have the time now so I'm offering a lower price which includes all of this lift. This will give about a 4. 5 inch lift. Enough to get full flex with the 35's that are on it. Will include lift components if asking price is met. Thanks for looking.