1966 Mustang Project

Have had a good bit of body work competed with only a couple of small areas that need attention. Around the gas tank in the trunk has some rust and needs repaired. Also the rear floor pans need to be replaced. I have the left floor pan. The right floor pan was replaced but they did a poor job it needs to be re-worked. The roof had some rust from the original vinyl top but it has been repaired.
Engine is a 302 that I had rebuilt in 1994 and has about 5k miles on it. (It came with the car when I purchased it) Transmission is a C4 and was rebuilt at the same time as the engine. The engine needs new lifters and a cam and both would need new seals but should be good to go other than that. I have a lot of chrome engine parts as well as a set of 351 heads that I was going to install. I had also planned to install a roller cam and lifters. Have all glass except rear. Suspension steering & brakes, lectrical system, auges and interior are all there and are original and need reworked. Invested over $12k in parts and body work so this is a great deal! Please email for more details.