1966 dodge short bed PATINA

>Up for your viewing pleasure is this 1966 dodge swb . This truck has the look everybody tries to copy. This is the real deal. This truck had been sitting for some time until recently. The guy I got it from had a new master cylinder and two wheel cylinders replaced. He also had new lugs put into the drums. I had a mechanic adjust the carb, hange the oil and put in a brand new aluminum radiator and new thermostat. The truck fires right up and drives well. It does smoke a bit upon start up. I have driven it around town a bit and it goes through the gears well. This was built when trucks were trucks so be aware there is no power anything. The previous owner buffed a little of the drivers door. I buffed a section by the antennae and this thing will buff out amazingly. I have the hub caps, he door handles the glove box the E emblem for the hoo, ne interior door panel. It is missing the drivers side interior door mechinism, sun visor and radio plate. I have located a door mechinism for 75 bucks. There is rust on the passenger side floor where the floor board meets the door well. It is very minor. The rocker below that on the passenger side has 5 pin hole where water drained. The drivers side door bottom corner has rust and a dent. The bed has surface rust and waves from being used as a truck. The hood appears to have opened up long ago while driving. It did over extend the hood and theright side hinge to hood area suffered. Also where the hood made contact with the cab left two cracks I. The hood. It looks as though somebody had put some kind of fastener through the hood and the drilled holes are still present. I have tried to take pictures of all the areas of concern. Overall the truck runs and drives pretty darned good and has killer patina. It is ready for some finishing touches to your liking and can be enjoyed right now. Please don't hesitate to ask any questions . Please do so prior to bidding. I have a clear title and will assist in shipping at your expense. Please see my feedback and bid with confidence! I personally would love to see this thing have an independent front clip put under it, lip the rear axl, uff it and roll it as a shop truck. Everybody does cookie cutter c 10s and fords. Be different and cool! Thank you.