1934 ford pick up truck p/u rat hot rod trog flathead

Up for you consideration is a 1934 ford pick up truck, ts in over all decent buildable shape, it does need lower patch panels as most of these do and they are all readily available, he subrails do need some work also, lease look at pics, have a used but in good shape front left cowl foot to patch the one that rusty, he suspension cunsists of a dropped axle, nsplit wishbones, 9 ford drums, do have front hyrdrolic backing plates and the adaptor kit to bolt them on to the stock 34 spindles, teering box is original and seems to be in very good shape, he truck does steer but the drag link has an old weld repair so i wouldnt run it, he rear end is a stock 34 ford rear also that has had hydrolic backing plates installed and 39 ford drums in the rear too. headlights are old BLC in super nice coniditon. steering wheel is 40 ford but its kinda rough. i do also have a set of stock pedals for it, he rear frame horns had been cut off, dont have any to go with it, hey could be made very easily with some tubing, he front crossmember was a NOS unit i bolted it, ts just held in by a few bolts for now as i figured id leave it up to the new owner if they wanted to rivit it in, ear crossmember is also bolted in for the same reason. tires are just rollers. could run them but they are weather checked. The motor is a 37 21 stud motor, t does turn over but was missing heads and intake when i got it so i rouneded some up for it, gain, dont know the condtion of the motor, d say it would need to be rebuilt to be safe. trans is just a empty mock up case but does have the correct rear trans mount on it. the doors do open and close and work decent, ut do need lower inner and outer patchs, he triangle door panels are there, am missing the drivers side door top to, he window regulators are also present. w/s frame is there but it does have some rust. cowl vent lid is there but im missing the hinge for it. the box is in ok shape, t had been shortened 5", t does have some thin spots where the old bed floor meets the sides, ut it is not a bad box but does need some work, ame with the box subrails, hey are in so so shape. tail gate is ok, eed top edge repaired.
the vehicle does come with a clear wisconsin title.
A down payment of $500 will need to be paid via paypal if you buy the vehicle, he balance can be discussed after.
I have sold alot of vehicles overseas, am completely fine with it but You will need to line up the shipping companies etc etc, work at home so i am available basically anytime for loading etc etc.
if you have any more questions feel free to get in touch and i will help anyway that i can.
thanks