1955 ford f-100 panel truck

This is a 1955 ford f-100 panel that I have had since 1990, hen I got this panel it was just a body & frame no motor or trans.Since that time I've had the body off to box the frame rails and add a 4-link rear end with TCI engineering adjusters and bars, oni coil over springs. It's a 9in ford rear end with 3:50 gears, 1 spline axles with drum brakes. Up front has disk brakes with the original straight axle and leaf springs, ew reversed eye top leafs were installed. Master cylinder / brake booster are from TCI engineering and mounted to frame.The motor is a newly rebuilt 425hp 396ci big block chevy, ith a 850cfm double pumper carb, luminum intake,electronic distributor with MSD 6a ignition box. Mounted to engine is a newly rebuilt turbo 400 trans with a 10in converter. Rims are centerline warrior 15x14 rear and 15x8 front on mickey thompson sportsman tires, ears are 29x18.50-15lt and fronts are 26x8.50-15lt. Now the Body, ll glass and rubber is new except for windshield, oth running boards, ack and front doors are original No rust! body mounts and body rubber is new, lso front doors have new hardware. Inside theirs two bucket seats a v-gate shifter and a tilt steering column.I have a new trans cooler that needs hooked up and the brakes need to be bleed again.Their is no fuse block or wiring, t has an ignition key that's wired to the starter motor and alternator so motor can run.The paint has some nicks and scratches over the years. Theirs way moor stuff that's been done to it! This is a running vehicle and has been in my garage since getting it. person is buying as is No warranty! you can call me 8:00am to 8:00pm west coast time, will answer any questions you might have.