1962 Ford Shortwide Unibody Rat Rod Slammed

Selling my 1962 Ford Unibody.
Years spent out in the West Texas sun and elements have created some of the best Patina that I have ever seen.
The truck has never been repainted and does not have any filler on it anywhere.
A few hundred hours have been spent getting it to its current state, ncluding:
A custom fabricated rear 4 link and c-notch with shock mounts
Heavy duty bag plates
Camaro front sub, eady for bags. Shock towers and shocks have already been added
Front cross member is set up for a SBF (currently have a 351 installed)
Truck was basically rust free when I got it with the exception of the floor near the toe board and front cab mounts. All of this area has been replaced with new metal, elded in, nd the seams were then sealed.
The front and rear glass were cracked so I removed them, leaned out the frame, nd have it prepped for installation. I have an original Ford rear glass that comes with the truck. The passenger side vent window is also gone. Both side glass is good.
The truck currently has a 351W roller engine from a mid 80’s truck. I disassembled it to check the internals and feel pretty confident that it could just be freshened up with rings and bearings and put back into service. I put it back together, leaned it up, nd repainted it, ut did not torque anything to specs.
Transmission, believe is a Ford AOD, hich also appears to be in good shape.
Note: this is not a running driving truck, ou will need to add your bags and air, rake calipers, ook up the steering, tc..

I have been an Ebay member for 15 years and have 100% positive feedback. Serious buyers can message me through Ebay and we can speak via telephone if you need additional information

On Aug-14-15 at 20:29:10 PDT, eller added the following information:

Additional Notes: There is a title for the truck

This is a short wide bed

Custom Fabbed 3 piece Transmission crossmember for Ford AOD