1996 Jeep Cherokee XJ 4wd Lifted

You are bidding on a complete rebuilt 1996 Jeep Cherokee with a 4.5" lift kit sitting on 33" tires.
What has been done:
Complete rebuilt engine
New Radiator
Radiator Hoses, Heater Hoses, Vacuum Hoses
New Gear Box
New Power Steering Pump
New Power Steering Pressure Hose
New Water Pump
New Distributor
New Ignition Wires
New Spark Plugs
New Alternator
New Starter
New A/C Compressor
New A/C Condenser
New A/C Drier
New A/C Hoses
New Battery
New Oxygen Sensors
New Shocks with reservoir (front & rear)
New Upper Ball Joints
New Lower Ball Joints
New Coil Springs
New Leaf Springs
New performance Front Suspension ( outer tie rod, inner tie rod, center link, drag link, track bar, sway bar links)
New u-joints in front rear rear drive shaft
Rebuilt Front Differential
Rebuilt Rear Differential
Rebuilt Transmission
New Clutch
New Throw Out Bearing
New Pilot Bearing
New Front Calipers
New Front Bearings
New Front Rotors
New Front Brake Pads
New Axle Seals
New Rear Drums
New Rear Wheel Cylinders
New Rear Brake Shoes
New Brake Hardware
New Front and Rear Brake Lines Steel Braided
Rebuilt Transfer Case
New Rims
New Tires
New Front Window
This drive train is completely rebuilt with all new parts in a professional shop out in Southern California, the Jeep is now located out in Minnesota, it has only 3,000 miles on the complete rebuild. This Jeep is Rino guarded to prevent scratches or rust, the under carriage is also coated. This Jeep drives like a brand new Jeep and is firm on the road. Everything works as it should, A/C blows ice cold, heater blows hot, turns on first try every time, all instrument cluster lights work, none are on. I haven't started on the interior yet, it still needs to be updated, Was planning on 5 point harness seats in front with a vinyl floor. Bumpers are still original was planning on upgraded to the Smitty built bumpers but never got around to it.
It would cost $13,000 to rebuild this Jeep in just parts not counting the labor, my loss is your gain.