2004 corvette Z06 commerative Custom Wide Body

2004 Corvette LeMans Commerative Z06 When purchased it had 125k miles.
This car has been built to participate in Optima Ultimate Street Car Challenge, Hotchkis Events or SCCA CAM S classes. I wanted a 100% Streetable Car that would kick Ass on the track.
Has Newly built original LS6 stroked to 383, 11to1 compression, Custom Comp cams, Ported and polished 234 heads, Comp Cams roller rockers, SS valves, Fast 102 intake, 90mm throttle body, 42lb injectors, This set up combined with the LG 1 7/8" long tube headers dynoed at 565HP 545 torque at the engine. Also has LG 3” exhaust all the way back.For California I have full set of Manifolds Cats and Titanium exhaust. Has a C6 Z06 clutch and Fidenza aluminum flywheel. Complete Original Trans upgraded to level 5 650Hp level, New Half Shafts, New Wheel bearings front and rear, MGW shifter, new drive shaft bearings and bushings. Completely rebuilt differential also upgraded to 650 hp level by Unitrax. new stock 3.54 gears. Has new Pfadt urethane bushings on all mount and a arm points, HD and lowered engine motor mounts to allow the Fast intake to fit. Has C6 Z06 calipers and two piece hats and rotors. Has LG lowered spindles. These lower the car ride height but retain the correct A arm geometry, Penske 3way remote reservoir shocks with custom valving. Turn five Power steering pump, Has L5 flared fenders to accept the 11” front and 12” CCW Wheels with 315X30X18 front and 335X30X18 Rear BFG Rival tires. Custom extractor hood. Corbeau custom seats, and Harness bar. Every Item on this car has been rebuilt or replaced. Car has less than 1000 miles since completion.
Below is a short list of cost to build this car covering just the major costs.
2004 Z06 high mile car $12000
Custom Performance LS6383 build $10000
Unitrax built differential $1600
Built T56 Trans and MGW shifter $2000
Custom Aluminum Radiator $400
Fidenza Flywheel & Clutch $1000
LG headers & exhaust $2600
LG race lowered spindles $2600
C6 Z06 Calipers & lines $1400
Colman 2 piece Hats and Rotors $1200
Wheel bearings & drive shafts $600
Pfaft Bushings $500
Turn 5 Power steering pump $500
Alt, Starter, A/C pump/dryer, Brake booster $1200
L5 fenders $2200
Body to fit fenders and paint $5000
Tune $600
CCW wheels $2400
BFG rival tires $1500
Corbeau Seats, harness bar, harness $1700
Splitter, Spoiler, side skirts $1200
Headlights $500
TOTAL $50100
Started with a nice car with engine problems and ended with a completely rebuilt Highly competitive Beautiful street Auto X car That is 100% streetable A/C blows cold, all accessories operate correctly and will hold its own in most series out there. Could be also be used for track days. Also have new set of passenger Harness belts that go with the Car.
As you can see there is a lot invested in this Car. Can also supply stock seats, new rebuilt flip up headlights and complete stock intake and exhaust if required.