1951 "Shoebox" Ford 2 Dr Sedan - Full Air Ride - 350 SBC/THM350 - 4 whl disc brk

1951 Ford Two Door Sedan

VIN Number 00B1SP156111

I’ve sunk over $24K into this car. I have a summary of all my receipts, nd have scanned them all and can email this file to serious buyers.

· Powertrain: 350 Small block chevy + 350 Turbo auto trans w/ Gennie Shifter

· Suspension: Complete Air Ride system – lays frame and front cross member on ground

o 4 bags and mounts

o 4 new shocks and mounts

o 2 480C Viair pumps (200 PSI)

o New 5 gal tank

o 7 switch box

o 30 amp relays

o Custom wire harness for air ride system

o 4 x 200 PSI 3/8” manifold valves

o 50’ of 3/8” 200 PSI air lines

o Custom rear 3-link bar set-up w/ adjustable panhard bar

o 2.5” C-notch on frame and custom body cut-out for pumpkin clearance

o Dakota Digital air ride gauge

o Fatman II dropped uprights

· Running gear:

o New drive shaft (Coast Drive Line and Gear – Ventura, A)

o 8” Ford rear end w/ new bearings and axels (Coast Drive Line and Gear – Ventura, A)

· Braking system: Complete, ew 4-wheel power disc brake system (4x discs w/ new calipers, iscs, ines, ual chamber master cylinder and booster) (JAMCO)

· Exhaust: Full new exhaust system from ram’s head manifolds back to rear bumper (full dual w/ glass packs); sounds great. Pipes “rap” perfectly.

o Exhaust was custom done after airride system install; carefully routed not to interfere w/ travel of suspension.

· New wheels

· New tires (Diamond Back Classics)

Custom Work:

· Custom peaked hood

· Frenched headlights (51 Merc rings from Night Prowler) (unfinished)

· Frenched taillights (unfinished) (Night Prowler buckets)

· New Mustang II 22 gal fuel tank; new fuel lines and pick-up

· New battery box w/ gel core battery

· New 12 volt harness

· Fully converted and rebuilt original gauges to 12 volt (Redline Gauge in Santa Clarita, A)

Refurbish Work:

· Remove and re-hang driver and passenger door w/ all new hinges

· Repair driver and passenger A-pillars;

· Rebuilt Carb

· Full Tune (new manifold gaskets; new valve cover gaskets; new distributor vacuum module)

Extra parts:

· 1953 Chevy grille w/ 7 teeth

· Extra set of interior and exterior (stainless) window trim

· Interior trim panels

Work Needed:

· Finish removal of drip rails

· Finish seaming of rear fenders

· Finish frenching headlights and tail lights

· Misc body work (front and rear aprons)

· Fenders, ody mounts, ockers and mounts need repair or replacement – extensive (rust and bad sheetmetal work)

· Rear seat

· Interior

· Trunk Firewall