1972 Chevrolet VINTAGE Tow Truck

href="https://www.tools4noobs.com/online_tools/youtube_xhtml/">Get your own valid XHTML YouTube embed code
May not be able to see video on mobile device! Try watching on computers. Please note that the tires are not straightforward in the video, herefor that's why the steering wheel looks crooked, ut I promise it's straight. All info of truck below

For sale is a 1972 C-30 Chevrolet truck with a fully functioning Holmes 440 wrecker body. I bought this truck along with a very solid, irtually rust free, 69 cab and front clip last fall and built it over the winter. I wasn't sure if I'd be able to keep it, o I took several pictures during the build so in the event of having to sell, he buyer would know what they are buying. I have a clear and up-to-date Iowa title in my name. I had the complete wrecker body along with cab and clip stripped to bare metal using a dustless blasting system. (That is much better than sand blasting.) It was primed with a self-etching primer and then painted a gloss red. Underside of body has been undercoated. The paint is driver quality, ot a show truck, as a few sags and imperfections. All 6 tires are in very good condition. The frame has been wired, rushed, nd painted. Here is a list of all mechanical parts that have been replaced. There are pictures also, o document the parts that have been replaced.
Brakes

• Front brake calipers and pads
• Front and rear brake hoses
• All steel break lines
• Rear brake shoes
• Rear wheel cylinder and axle seals
• Master cylinder
• Electric over hydraulic solenoid for E-brake

Mechanical

• Clutch plate
• Alternator and voltage regulator
• Fuel pump and fuel filter
• Carb kit
• Complete tune-up
• Starter solenoid
• Power steering and alternator belt
• Valve cover gasket
• Trio gauge kit
• Heater hoses
• Engine oil and filter
• New coolant
• 160 degree thermostat

Lighting

• Tail lamp assemblies (In wrecker body)
• Backup lamp assemblies (In wrecker body)
• Front turn/park lights
• Rear spotlights on wrecker body
• Flashing beacon on
• All new wiring on wrecker body into cab
• Tail/Turn assemblies on wrecker body

Interior

• Parts from LMC
• Seat cover
• Carpet
• Sill plates
• Windshield molding
• Door weather strips
• Dash pad cover
• New window seats and felts
• Glovebox liner
• Window crank handles and floor mats

I also installed new belting onto the wrecker sling assembly. The wipers and heater fan function. The original AM radio is not connected because the speaker was in poor shape. It has the original 292 6 cylinder engine and 4 speed transition. With the pto which is what powers the winch on the wrecker body. The truck runs and drives great. I have only driven it about 20-25 miles since I completed it, ue to winter weather and road conditions.The truck is located in Stout, owa, 0673 which is 15 miles west of Waterloo/Cedar Falls. Please call with any questions: 319-239-5238Don't bid if your're not going to follow through with buying the truck.I can store inside for 15 days as long as it's paid in full.$1000 non-refundable deposit due immediately after auction ends.Remainder paid in cash within 7 days of auctions end.