1998 Honda Prelude Type Sh with 150,000 miles. Fully built and Stage 2 PnP head with oversized valves, dual valve springs, titanium retainers, silicone bronze valve guides, viton stem seals, etc. BC Crower Stage 2 NA cams brand new. More than 1200 in parts into head. ARP head studs, brand new gates racing timing belt, cometic head gasket, kms block guard, vms cam gears, Raxles axles custom built, unorthodox racing pulley full set with new belt, tanabe medallion exhaust, test pipe, PLM tri Y headers brand new, Injen intake, Mugen Showa Suspension, type s strut bar, window visors, all 4 new wheel bearings, knock off rear strut bar, new alternator, new starter, Greddy Emanage Ultimate custom wired for h22 with new Boomslang harness, freshly powder coated RSX wheels, all new brakes and rotors, all new gaskets. Car was on Dyno and vtech stopped engaging and was immediately taken off dyno and put in storage. Could be vtech solenoid, oil pump, or bottom end work. Because of this I purchased an assembled bottom end TYPE SH with under 100k miles and TYPE SH transmission with ATTS box and matching mileage. This is included in sale. CAR HAS ALL FRESH BODY WORK AND NEW FACTORY PAINT!! Also comes with brand new authentic wings west body kit. Rear lip is not painted yet but can be if car is purchased for right price. Skunk 2 shift knob and fidanza short throw shifter. Had our 2nd child and cannot afford to finish project. Well over $12,000 spent over past 2 years on this and it has not seen the road yet! Im sure there are a ton of other new parts I did not list.