1957 Willys wagon

1957 willys wagon project that was started but needs finished. It has a 6.0 L and a 4L65E trans out of a cadillac escalade. Has dana 44 axles, disk breaks in front and power steering installed. has 2 sets of brand new leaf springs custom made by alcan spring out of colorado, one set is stock height wich is currantly installed brand new no miles and the 2nd set is made to go spring over and has 2 inches of lift built in so a total lift of about 5-6 inches. I have all the spring perches and new ubolts to put those springs on. The frame has been boxed with 3/16 plate to just behind the trans mount. bigger gas tank installed. New sheet metal smoothed out firewall, new front floor pans and outer main braces installed, left rocker is new. everything that i had access to was por 15 (inside all floor braces and cavities) new left outer wheel well and quarter panel installed (quarter needs a little finish welding by back door, plug welds) I have a new quarter panel and outer wheel house for the right side that needs to be installed and that will take care of all the rust in the body. the roof was stripped to bare metal and body worked and primed with polyester primer. I have all the front sheet metal and its in good condition just strip it and body work. Have all the glass but i would replace it because its the original. has fron and rear seats out of an unknown car look nice though. interior is complete. overall its a very solid and complete project that could be finished up fairly easy and wont cost much.If you are a serious buyer feel free to ask any questions or for specific pictures.have a clear title. thanks