This is a 1966 T code six cylinder 200CI 2-V convertible with 3-speed tranny. I have not run the car since bought in 2003 but at that time the engine ran and tranny worked. Brakes have been removed so they wouldn’t rust together. Manual steering which is fine if you stick to the six cylinder. This was a northern car that sat on the ground apparently and rusted out all of the floor and subframe. Top is totally gone. From the rockers up not as bad. But definitely a full project car. I have the seats but frames are rusty. I am including the rear trunk floor replacements as seen in photos. Tires are bad but will roll around for restoration. The body is amazingly straight considering how much rust there is. The trunk lid and hood close firmly. The roof is manual.
1966 Mustang Convertible Project 6 Cylinder Roller
1966 Ford Mustang Convertible Base 6 Cylinder Nice Project CHEAP
1966 Ford Mustang Coupe Base 6 Cylinder Pwr. Steering Cheap Project Car
1966 MUSTANG CONVERTIBLE PROJECT
1966 Ford Mustang v8 convertible project
1966 Ford Mustang Convertible 289 Auto Project
1966 Ford Mustang Base 3.3L 6 cyl. Convertible, Project Car
1966 Ford Mustang Convertible T Code Project Car
1966 Mustang Convertible Barn Find Resto Mod Project
1966 Mustang Convertible 8 Cylinder Green Dot 3spd Auto RWD Red A/C Rally Pack