1998 Subaru Legacy Outback STi Swap , Built Engine

I am selling my custom built 1998 Subaru Legacy Outback with a STi swapped engine,transmission and differential. It is still running the 5x100 bolt pattern with a set of Rays GramLight 57Extreme wheels with Michelin SuperSport tires with less than 1000 miles on them both. The interior has the STi seats front and rear, ears were modified at an upholstery shop to allow for the flip and lay flat to work properly. The instrument cluster and climate control back lighting has been converted to blue led to match the Alpine head unit and the Auto Meter Cobalt gauges. All of the suspension has been upgraded to Whiteline sway bars,bushings and strut tower brace. The only bushings not changed are the rear diff and rear cradle mounts, had fears of increasing too much vibration to the chassis. I had a set of rear cradle lock bolts made as none are commercial available for this model. The engine is a fresh build, ith approximately 200 miles since installation. It has a mild break in tune and will need to be finished to maximize and smooth out the drive ability. This has been a project of mine for the past few years, nd it has come time to move on as I no longer have the time to work on it like I did. I am making every effort to accurately list all of the modifications, arts and enhancements that were made. Below is the list, tried to break it down into sections and I have a folder full the receipts for the build to this point.
Engine- Built STi 2.5 Liter using
Rods- Manley Turbo Tuff I Beam
Pistons- Carrillo 100.5mm 9.0:1 compression, ent to Calico Coatings for skirt and dome coatings
Crank- Stock STi Crankshaft
Camshafts- Brian Crower 272 with matching valve springs
Bearings- King rod and main XPG bearings
Intercooler- GrimmSpeed Top mount with thermal coating
BOV- Cobb XLE BPV
Oil Pump-Stock STi 11mm
Has Killer B Windage tray and Oil pick up
Fuel Injectors-ID1000 with matching top feed conversion rails and fuel lines
Fuel Pump-Walbro 255
Intake was ported and polished, asket matched to runners, GVs were removed, oles professionally welded shut and have Grimmspeed phenolic spacers and widemouth gaskets
ARP Head studs
Cosworth Billet timing belt guide
Greddy magnetic oil drain plug
Perrin custom cold air intake with K&N filter
AN lines for turbo and AVCS oil feeds
Newest STi oil pan - improved baffling
Turbo-VF4, upgraded by SixStarSpeed to RHF55 with 10 blade billet wheel with port and polish
Gates timing belt and water pump kit
SPT Turbo heat shield
GrimmSpeed 3Port boost control solenoid
Napa ReMan starter
Engine is set up to run E85 with the appropriate tune
Has custom air oil separator with RedHorse custom made AN lines
Perrin Lightweight Crank Pulley
SPT Engine mounts
Transmission:
STi 6 Speed
SPT short throw shifter with SPT shifter bushing
SPT Transmission mount
New slave and master cylinder with braided stainless clutch line
Southbend clutch kit, tage 2
Competition Clutch Lightened Flywheel 15lb steel
Custom Titanium Shift Knob form WC Lathe Werks - Pictures don't do it justice.
DCCD Pro DCCD controller with status lights in cluster and factory controls in console
Interior:
Custom made front door panels housing Kenwood 6x9 speakers in a fully dynomated door with JL Audio tweeters in the factory pods
Rear doors have Kenwood 6.75 rear speakers
Alpine Headunit with bluetooth and Ipod interface, ith a Kenwood 4 ch amp
STi Seats front and rear- fronts have aftermarket seat heat kit using factory switches
Jp Coachworks Alcantara shift boot and console wrap to match seats
Stock floor mats dyed black with STi Plates
20% window tint
Has rear cargo rubber mat and rear cargo tonneau cover
Custom 3 Gauge pod below radio housing AutoMeter Cobalt Oil pressure, ideband, nd Boost gauge
New cup holder above radio
I have a New Audiovox alarm that I will include that will need to be installed
SPT STi Key
Wiring harness was custom made by IWIRE - no hack job
East Coast Swappers DBW pedal bracket
COBB Access Port
STi Pedal Set
Exterior:
GramLight 57 Xtreme 17x9 +40
Michelin Super Sport 245/45/17- less than 1000 miles on wheels and tires
Custom tinted rear taillights
IPF Amber fog lamps with KC stone shields
RFRB Grille
Subaru 2 bike rack by Thule
Custom tinted imported fender turn signals- never offered in US
Tein Hood Shock kit- no longer available
New hatch struts
Brakes and Suspension:
Metallic powder coated 4 & 2 pot brake calipers
StopTech drilled and slotted rotors
Hawk HPS brake pads
Goodridge Stainless brake lines
StopTech High Temp brake fluid
BC Coilovers
Whiteline front strut tower brace-front
Whiteline bushings-ALL suspension was replaced except rear cradle and diff mounts
Whiteline Bump steer correction kit
Whiteline Caster correction kit
Whiteline Front and rear sway bars, ar mounts and end links
The handling on this car is incredible and still has a good ride that doesn't beat you up.
The paint is in good condition considering its age, he hood has rock chips and there is a small rust spot in the RR quarter panel. There is a small bubble in the right front fender that has been there since I've owned the car and hasn't moved.