The frame is of Dennis Curtis manufacture and is one of 4 made in the lower mainland in the early 70s. Originaly made to fit Vincent V twin engine. This frame has been modified to 28 degree rake angle . ame as a Manx plus front down tubes have been welded to fit Norton engineI raced the bike in the NW at SIR and PIR. It has approx 60 HP at the rear wheel @6800 rpm Serial # for engine M2/119927. I make it 1967? The machine is unique . ould make a nice classic racing bike or for a collector . In fairness there appears to be a hair line crack on the upper engine plate on the timing side. asily repaired. ENGINE----Hayward 40mm belt drive Terms And Conditions ---- $1000. 00 deposit is due within 24 hours of auction close. Balance of funds due within 72 hours or 3 days of auction close There are NO Warranties expressed or implied of any kind and as is condition. I have described the bike to best of my ability The winning bidder must call me to verify purchase and make arrangments to complete sale Shipping I will assist with shipping arrangments. however the buyer pays all shipping costs ----Boyer Ignition----Accell Coil I reserve the right to cancel bids and/or auction at any time for any reason . The sale is final. Thanks for looking and good luck----Mega cycle cam #5600----10--1 comp----Vernier scale cam timing----Custom made oil tank and breather on side of tank----Concentric carb 32mmOther ComponentsRear wheel HusquvarnaFront wheel LaverdaForks LaverdaTach Suzuki water buffaloGas tank RickmanTyres Avonlevers Magura