1976 Suzuki GT750 Cafe Racer by Bexton Craft Motorcycles

This 1976 Suzuki GT750 Cafe Racer project is called "Threesome" due to it's 3 cylinder engine configuration. If you are familiar with this model you will know that when those three cylinders start firing in rapid 2 stroke fashion anywhere above 4500 rpm it will make the hair on your neck stand up and give you goosebumps. The sensation is sublime. This bike has been part of my collection for the past 2.5 years. The Bexton garage recently acquired another GT project bike that will replace this one.

The donor bike had 16XXX miles on it and the motor ran strong without any leaks or other issues. Due to this the motor was given a fresh water pump and a fresh coat of black paint. Otherwise it was left alone.I have put another 1500 trouble free miles on it since the build was completed.It has since started to push a bit of oil out the breather when ridden too spiritedly, hich indicates that the crank seals are starting to go. I installed a pipe to catch the oil and then drain it back into the engine to contain it. Performance remained unchanged due to this. However it will require a fresh set of crank seals if you plan to ride it cross country. I am pointing this out so as not to catch the new owner by surprise. But if you plan to just ride it occasionally like I do it will probably be good for years to come, ust remember to change the oil regularly.

The frame was modified to suit the Rickman tail section and seat. The entire frame and every single bracket was also powder coated. Electronics and battery are now housed under the tail. It has also been equipped with updated modern electronic ignition and voltage regulator and rectifier. I added a few gussets in the center triangle to tighten up the frame a little. The front end comes from a Suzuki Hayabusa, omplete with forks, heel and 6 piston caliper brakes. The front fender is from a Ducati Monster. In the rear I built a custom swingarm, sing the swingarm and brake from a modern Suzuki 750 Katana as a donor. The Katana swingarm was shortened to retain the original wheelbase and some shock mounts welded on to retain the stock twin shock setup. It now runs on needle bearings instead of the original plastic bushings. I used a Suzuki SV650 rear wheel and also SV650 race rear sets. The fairing is from a Ducati SuperSport. The motor was adorned with a Jethot coated set of Jemco chambers and the carburetors cleaned and re-jetted to suit the chambers and K&N tube filters.

The bike is very well sorted and easy to ride, ut also a wolf in sheeps clothing, hen you hit 5000 rpm you better hang on when that 2 stroke power band kicks in. The rear shock are Chinese knockoffs imitating a famous brand, o do not mistake them for being the real deal. They work as well as their origin suggests under normal riding conditions. This is an old bike design and the kickstand sits under the left chamber not leaving much room before things start touching down so you cannot expect to ride this bike at Grand Prix speeds anyway. The Hayabusa forks work extremely well and so do the brakes.

I have a very detailed write up of the build with pictures and some video on my website MyBikeProject where you can see some of my other builds also. The bike was also featured on Silodrome Silodrome

If you have any questions please feel free to ask. Local pickup only by your chosen shipper. I will work with the buyer to enable pickup locally.

On Aug-11-15 at 07:30:02 PDT, eller added the following information:

Video of the bike riding can be seen here: GT750-Riding